Porous concrete will require priming. Apply HYFLOOR EPOXY PRIMER by roller at a
dosage rate of 0.15 – 0.2 kg/m2
depending on substrate condition. Broadcast with
quartz 0.4 – 0.7 mm. onto wet primer.
Allow primer to dry. Then remove excess sand with vacuum cleaner.
Mixing
HYFLOOR 181LF is prepackaged with specific ratios. It is recommended to mix full
unit only.
Mix part A and part B together with a low speed electric stirrer for 30 second.
Ensure that mixed material blended well.
Add color pigment (part D) into the mixed and blend to uniform color appeared.
Gradually add part C to the mixed resin parts. During the operations, scrape down
the sides and bottom of the container with a flat or straight edge trowel at least
once to ensure complete mixing. Continue mixing for minimum 2 minutes to ensure
the final mix being totally homogenous.
Top coating
Apply the mixed HYFLOOR 181LF with a toothed trowel or pin screed to the correct
thickness, achieving a flat surface. The topping is then rolled with a spiked roller to
remove entrained and entrapped air.
Take care to spread newly placed materials across the transition of previously applied
mixes before the surface begins to set.
Allow for minimum 14 hours before open to light traffic.